Member #185153

Member Since: January 5, 2011

Country: United States

  • Tutorial - Beginning Embedded Electronics - 2 | about 2 years ago

    I can’t get the pocket programmer to recognize the chip. It works on an Arduino, so I know the computer setup and the pocket programmer are OK. I have verified 5v and gnd to the correct pins. I discovered an error in my reset pin connection. I had the 10K resistor connected to gnd instead of 5v. Could that have fried the chip? If not, what else can I check?

  • Product DEV-08284 | about 3 years ago

    reemrevnivek:

    This has ample room for a C program. You’ll want to use the free CodeSourcery GCC toolchain.
    I’ve ordered the board; it’s too good a deal to pass up. It hasn’t arrived. The Codesourcery docs for the EABI free package say I’ll need a linker script, which they don’t include for this board. Is one available, or can I create one, or is there another technique that doesn’t require one?

No public wish lists :(