×

Prolonged severe weather across the U.S. is causing delays including the ability to transport and deliver packages in certain cities. Please see here for more details. Thank you for your continued support and patience.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

dizot

Member Since: January 11, 2011

Country: United States

  • This is a great way to program boards with no additional cost per PCB. I've been doing this on my own boards for a few years, and it works great. My adapter board uses the standard ISP header as input, and spits-out the pogos in the same arrangement : http://bitpuppy.com/Bitpuppy.Bed.of.Nails.ISP.Programming.Adapter.htm

  • I just wanted to share my experience with using the RN42 and RN41 at high [115k+] data rates. It may apply to lower rates, but I haven't tested. These devices seem to disconnect from the BlueTooth host after communicating for a short period [in some cases less than 1 sec]. After some trial-and-error, I realized that the power supply needs decent bulk capacitance. I didn't test exhaustively for the optimal cap value, but bypassing power via a low-ESR 470uF capacitor totally stabilized my module. Now it works all of the time.

    Hope this saves someone else some aggravation.

No public wish lists :(