×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

heliguy

Member Since: January 12, 2011

Country: United States

  • After I install Atmel SAM BA and connect this board via USB. The system is unable to identify this board. Do I need to install some USB driver for this? How can I make this work?

    Thanks

  • If I just replace the 8Mhz resonator with 16Mhz and use external power supply of 5 Volts. I think I can run this at 16Mhz. Of course we will need to replace the following line in boards.txt as follows.

    Old content "mega2560v.build.f_cpu=8000000L" New content "mega2560v.build.f_cpu=16000000L"

    Does anybody see any issue with this? Thanks

  • In the schematics I see that the AREF is not connected to VCC. Is't this wrong? I tested it and it seems to think that AREF is VCC ( 5v) but how can it do so when AFREF is not connected to VCC, I have no idea.

  • The schematics of 5V and the 3.3 Arduino Pro mini seems to be the same. So I was wondering what is the exact difference. It is just the crystal frequency and the Voltage regulator?
    Thanks
    heliguy

  • I intend to drive standard RC controlled servos using two signals. I will have a select wire which will choose which signal the servo is to respond to. Can I use this chip do that selection? I have a feeling that it will work OK.
    Thanks

  • I Intend to use this to transfer telemetry data from an RC plane. I was wondering if this would interfere with the RC spread radio radio which also works at 2.4 GHz. There are other filers as well and I would hate to be reason for their plane/heli crash.
    Thanks

No public wish lists :(