×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

MikeA

Member Since: May 14, 2007

Country: United States

  • It would be good if the part library was updated, but for now you can just put a small "wire" in the tRestrict or bRestrict layer between the pads and it will stop the polygon fill going in there.

  • I've received a few of these modules, and while some have the 1M resistor marked 1004 across the crystal (which the data sheet says is not really necessary), 3 other modules have a resistor marked "310" across the crystal.
    31 Ohms is a long way off 1M ohm. Is there any reason for this?

  • I've also had nothing but trouble with Prolific chipset USB-Serial converters. They just seem to stop working constantly - requiring an unplug/plug to get them working again. And I've also experienced the issue with newer drivers being even worse than the older drivers.
    Please Sparkfun see if you can find a USB-Serial converter that uses any other chipset.

  • The link to the Eagle files goes to the same PDF as the link to the schematic file.

No public wish lists :(