Doing some holiday shopping? Please check here for shipping deadlines to make sure your order arrives in time.


Member Since: January 26, 2011

Country: United States

  • Hello,
    I asked directly at LinkSprite company support. They told me I have to send the camera back to the factory to replace/fix the firmware. Looks like it is not possible to fix this problem by myself.
    So my conclusion:
    This is a nice camera wich much better communication and stability performance than the one from 4dSystems, but:

  • Hello,
    I have a big problem:
    I send the wrong command to set the resolution. It should be "56 00 31 05 04 01 00 19 22" but I sended "33" at the end instead of "22". After reboot my camera don't finish init. It don't respond to my commands to change the image size to the correct value, actually it don't respond to any command.
    Is there a way to clear the EEPROM or reset to a default state?
    This is the 2nd camera where that happens (for the first one I didn't recognize, it was the wrong code that killed it but when I think back, it didn't work after changing the resolution)
    Please HELP!!!!

No public wish lists :(