×

Due to the impacts of the coronavirus outbreak, we are experiencing longer than normal lead times on certain products. We encourage back-ordering out-of-stock items to receive them as soon as possible.

jcsquire

Member Since: January 26, 2011

Country: United States

  • You're mixing up things. You don't select a programmer model to use this board; you select a programmer if you're downloading the bootloader to a blank Atmel chip. What you do depends on what you're trying to program. For example, if you're programming just a bare Atmel ATMega with the Arduino bootloader already installed, connect this board to your chip's RX, TX, reset (the DTR), 5V, and ground, and program the chip as if it were mounted in an Uno development board. In that scenario you can set the programmer model to anything since you're not using it.

No public wish lists :(