×

SparkFun will be closing early at 3:30 Friday 5/27 and remain closed Monday for Memorial Day (5/30). Orders placed after 2pm MT on Friday (5/27) will process and ship out on Tuesday (5/31).

AriBlue

Member Since: April 1, 2011

Country: United States

  • You have to use the GPIO pins on the Pi.

    I connected mine as follows: VCC to 3.3v, OUT to GPIO18 and GND to GND with a 160ohm pull-up resistor on the VCC.

    Then I used LIRC to setup the remotes / read the codes. There are many guides online on this. Hope this helps.

  • Great little receiver!! Easy setup on Raspberry Pi / Raspbmc with LIRC.

No public wish lists :(