Member #220465

Member Since: April 22, 2011

Country: United States

  • I’m trying to get some output from the sensor version 3.0 (number 2913) but unfortunately the voltage level doesn’t change when I flex my muscle. Here’s what I did: I’ve setup the hardware as indicated in the pdf using the +9 and -9 volt batteries. I ran the AnalogVisualizationArduino file. Looping through the pins the voltage level stayed the same, between 360 and 400. This change is random, has no relation to my movements. I checked the power and output with a multimeter but here also the signal pin output stayed around 0.036V

    Did I miss something basic here? Is there a tutorial to test my setup? Or is something wrong with the board, perhaps?

    Thanks very much in advance for your help, best, Anja.

No public wish lists :(