jtallent

Member Since: May 3, 2011

Country: United States

  • Product SEN-10061 | about 2 years ago

    Can you tell me how you are hardware interfacing the camera to the PC ? I tried SparkFun’s RS232 Shifter SMD but could not snap a single image from the evaluation GUI. Thanks.

  • Product SEN-10061 | about 2 years ago

    I tried to interface this TTL camera to a PC using the SparkFun’s RS232 Shifter SMD. I’m supplying 5V to both the camera and shifter. I am using the evaluation application “LSY201.exe” to take a single shot but all I get is the message: “PhotoOnce empty order queue” at the bottom of the GUI. The Tx/Rx lights on the shifter are flashing so I know something is working right.

    Any help would be greatly appreciated here. Thanks.

  • Product SEN-10061 | about 2 years ago

    Were you ever able to interface the camera module to a PC? Do you have the TTL version ? If you were successful with the PC interface can you tell me about the circuitry used between the camera and PC ? I tried the RS232 Shifter SMD but was not successful. Thanks for your help.

  • Product PRT-00449 | about 2 years ago

    Hello,

    Has anyone successfully used this product (RS232 Shifter SMD) with the LS-Y201 TTL Camera ?

    Thanks for your Response.

  • Product DEV-09802 | about 3 years ago

    I soldered the microSD shield like the one in the photo above, i.e. I did not use the stackable header. I was planning to use the protype area to add a device requiring 5V power and GND. The issue I have is that the microSD shield does not connect the ground to the protype area. I don’t know why this is so. Nevertheless can anyone tell me the best way to pass GND to the prototype area?
    Thanks

  • Product DEV-09802 | about 3 years ago

    It works. Very simple once the soldering is done.

  • Product DEV-09802 | about 3 years ago

    Can anyone tell me why the ground pins from the Arduino to the microSD are not connected to the prototype area.

  • Product SEN-10061 | about 3 years ago

    Do you mean the 5th pin on the Camera (TV). I believe the TV is only used for a direct video connection to a television (PAL).

  • Product PRT-10527 | about 3 years ago

    Can these be used to attach a Arduino Shield to the Uno?

  • Tutorial - microSD Shield Quickstart Guide | about 3 years ago

    I received this product today and noted that the shied does not fit on the UNO as depicted in the image above. The shield rest on the the USB connector making it difficult to make a good header pin fit and possibly a poor connection. Is this a defective microSD Shield or Defective UNO (both are new).

No public wish lists :(