fizzymagic

Member Since: May 22, 2011

Country: United States

  • The commands that can be sent to the receiver are in the UBLOX 7 protocol mentioned in the description. Of course, this will require soldering a lead to RX on the board. For the protocol, see:

    https://www.u-blox.com/sites/default/files/products/documents/u-blox7-V14_ReceiverDescrProtSpec_%28GPS.G7-SW-12001%29_Public.pdf

    In my case, I would want to set the serial post parameters to a higher data rate, which is achieved via the CFG-PRT message.

No public wish lists :(