thereisnocat

Member Since: May 22, 2011

Country: United States

  • Product DEV-10342 | about 3 years ago

    Doesn’t work for me. The diode pulls the voltage up to 3.6 volts, but I still get nothing but 80 and 80 0 0 0 0 0 0 0 0 0 …. when I use the serial example sketch and enter the commands in the comments.

  • Product DEV-10342 | about 3 years ago

    I found this post on the Arduino site that may shed some light on this:
    http://arduino.cc/forum/index.php?topic=66554.0
    Reading this makes me wonder if maybe Sparkfun developed the board with the Arduino Pro 3.3v/8MHz but didn’t test it with 5v Arduinos. I’m finding that my Arduino Uno displays the same sort of symptoms described in the post on the Arduino site.
    I think I’m going to test the shield with my LeafLabs Maple, which runs at 3.3v, and see if that makes it work better.

  • News - Project Gado | about 3 years ago

    It’s Detroit. They would never say “beer and soda”. It would be “beer and pop”.

  • Product DEV-10342 | about 3 years ago

    Doubtful. I haven’t seen anything about I/Q output in the chip’s datasheet. That’s the down side of having an entire radio on a single chip.

No public wish lists :(