Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.



Member Since: May 26, 2011

Country: United States

  • I ordered two Openlogs. One came with firmware v2.5 and supports the 'reset'-command in commandmode. The other (as I figured out after some hours of testing around and cursing (g) was only firmware v2.41 which doesn't support resetting.
    I tried to compile v2.5 using the latest Arduino-IDE and following the steps explained on the datasheet precisely.
    At the first try my OpenLog suddenly only logged chinese characters (which were definitively not "thrown" at him). Now after a reboot of my computer v2.5 won't even compile because some error in the 'special' HardwareSerial.cpp supplied for programming v2 onto OpenLog using the Arduino-IDE.
    I then tried to upload the latest .hex file using avrdude. But the latest .hex-file on GitHub is v2.41. Could you please make a .hex for v2.5 available? Thanks in advance.

No public wish lists :(