×

Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.

Lolage12

Member Since: July 5, 2011

Country: United States

  • To use both of the sensors in a wheatstone bridge, you must reverse the polarity of one sensor.
    Sensor 1 black wire and Sensor 2 white wire on +5VDC.
    Sensor 1 white wire and Sensor 2 black wire on GND.
    Then you can measure the voltage difference on both red wires, and the voltages from both sensors will add up. If it's negative just reverse the polarity.
    Hope this helps... :)

No public wish lists :(