Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #23671

Member Since: August 29, 2007

Country: United States

  • Hi all,

    I'm really frustrated with this board right now. It's the second one I've purchased in the past three weeks and I just can't get either of them to work with LinuxCNC and these motors: http://www.sparkfun.com/products/10846

    I'm about to return the whole lot as they just don't seem to play nicely. The most I've been able to do is get the motor to hold its position and make a noise that sounds like it's stuck. I'm pretty sure everything is connect correctly as I've followed the datasheets to the letter. I'm using a 12V, 2.5A power supply to the board and trying to get it to work with just one of the 3V, 1.7A motor.

    What am I missing...?

No public wish lists :(