davidc

Member Since: July 15, 2011

Country: United States

  • Product PGM-00012 | about 2 years ago

    This does not (and probably never will) work with AVR Studio version 5, since that only supports JTAGICE mkII and later

  • Product TOL-10029 | about 3 years ago

    There must be some considerable variation in the build quality of these things. For $4, I wasn’t expecting the world’s best cutters, but I was expecting them to actually be able to cut.
    The product I received has the blades so far out of alignment that the best it can do is squash the wire, and then only if you exert immense pressure (in the meantime lifting the tracks off your board). Photo cutting a standard LED lead.
    There are screws that might be able to adjust the alignment if they weren’t so stiff I can’t actually turn them.

  • Product PRT-09749 | about 3 years ago

    The poles aren’t switched, you are just mistaking the little “+” handle used for moving the components for a “positive” marker. I’ll agree that’s pretty confusing though!

No public wish lists :(