×

SparkFun Electronics will be closed in observance of memorial day on Monday, May 29th. We will resume normal business hours on Tuesday, May 30th. Any orders placed after 2pm Mountain Time on Friday, May 26th will process and ship out on Tuesday, May 30th.

PedroH

Member Since: July 28, 2011

Country: United States

  • The product dont arrived here yet…..
    iam waiting and when it arrives, i will answer you.

  • Well Looking at the schematic of the breakout and the datasheet of the module, i think it can work fine with arduino just like this:
    UART0-RX-GPIO0 - ARDUINO D1
    UART0-TX-GPIO1 - ARDUINO D0
    VIN3V3 - ARDUINO 3v3 pin
    GND - ARDUINO GND
    VBAT - ARDUINO 3v3 pin too
    EN1v8 - ARDUINO 3v3 pin too
    And i can put the 2 leds on the GPIO30-LED1 GPIO30-LED2 and the GND from arduino.
    On Arduino use Serial.begin() and start communicating via UART.
    If incorrect please tell me cus when the module arrives i will try use this ‘schema’ to run it.
    ty

  • Hi Robert, thankyou for aswering.
    But i have buy the 10808 to use with arduino, will not work?
    if not, can you tell me if i can buy just the red board from 10505 ?
    Thank you.

  • Sorry the question but this can by easly wired direct to the arduino too?
    ty

No public wish lists :(