Member #24438

Member Since: September 18, 2007

Country: United States

  • Just wanted to say that this is a great board to use with a Pi Zero. The 5v VCC will power the board and the I/O is at the 3.3v that the Pi needs. Just connect up VCC to pin 4, GND to pin 6, RXD to pin 8 and TXD to pin 10 and use your favorite serial program to connect at 115200 baud. This also works with other Pi boards as well, though I'm not sure if the bigger boards can source enough power from this cable or not.

No public wish lists :(