×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

TravisF

Member Since: September 14, 2011

Country: United States

  • Actually the problem has not been resolved. What happens when you select "No Power" is TARGET-PWR still connects to the programmer through a 22k resistor to CTL. CTL is pulled high by the programmer when in a non-programming state (in order to tri-state the buffer IC). Thus the target board is powered via the CTL pin (which is at 3.3V) through a 22k resistor . The programmer needs to be redesigned to resolve this issue.

No public wish lists :(