Landrew

Member Since: September 16, 2011

Country: United States

  • Product SEN-10121 | about 3 years ago

    Ok, so I think I figured out the device address issue. The base address + R/W bit was confusing since NETMF adds it automatically. But the acc is still reading 0 0 0. It seems I can’t set power ctl reg to Measure!

  • Product SEN-10121 | about 3 years ago

    ITG-3200 seems to work fine. But the ADXL345 accelerometers are showing only 0’s. I try to set it to measure by setting reg 0x2d to 0x08 but when I read the register again it’s value is still 0x00. The device addresses confuse me: 0xd0, 0xd1, 0xA6, 0xA7?

No public wish lists :(