SparkFun will be closed Nov 26th and 27th for the Thanksgiving holiday. Orders placed after 2:00pm MT on the 25th will ship out Monday the 30th.



Member Since: September 24, 2011

Country: United States

  • Same problem here. When there is no pressure applied, the mag does not send the I2C ACK at all (wrote a little program for my MCU that iterates over all the 7-bit possible addresses, it finds the acc and the gyro, but not the mag). When I press it really hard (put two plastic cards between the breadboard and the sensor, then I press it as hard as I am not afraid of breaking the thing) the mag responds and I can make measurements properly.
    Edit: Ok, I maybe went a bit too far. It has now detached from the PCB.

No public wish lists :(