blakester

Member Since: September 27, 2011

Country: United States

  • I’m confused about the +5VDC coming off pin 3. Using my multimeter, I connected my FTDI Basic Breakout to my laptop (no Arduino) via a USB cable. I then proceeded to confirm that I have +5VDC between pin 1 GND and pin 3 (incorrectly silkscreened as 3V3). My confusion is, if I am using a 7805 Voltage regulator to power my breadboarded Arduino with 5 volts, shouldn’t I then leave pin 3 from the FTDI Basic Breakout not connected?

  • Can this be used with a bluetooth headset?

No public wish lists :(