×

Forget something during Black Friday/Cyber Monday? Check out the Week of Deals!

Alamorobotics

Member Since: September 30, 2011

Country: United States

  • Howdy... I got this rover a while ago, March 2012, and finally thought I was ready to test out the encoders... However I cannot get the Encoders to work, I supply 5V to the Red wire, ground to the Black and then input the white and yellow to my encoder input. After a while when I could not get it to work with my propeller board, I hooked it up to my oscilloscope to check the outputs and there is none, 0v constant... I tried a 10K pullup to 5V, still no pulses... Then tried the other 3 encoders, they seem dead as well... Did I miss something or does it look like all my encoders are dead ?

No public wish lists :(