Member #255836

Member Since: October 2, 2011

Country: United States

  • If I solder “header pins” to the 6 pin ICSP port (the 6 solder holes on left side, as is the USB port) and properly connect a
    PICKit3 module there, I should be able to use the MPLAB IDE to
    program/debug the CUI32 in C32/Assembly. Correct?
    It sort of defeats the purpose of StickOS, but I want to try and run FreeRTOS and other things on the board after I try StickOS Basic (I can always restore the StickOS if need to.)
    Anything I need to be cautious of?
    Thanks in advance!

No public wish lists :(