Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.


Member Since: October 10, 2011

Country: United States

  • the output is already at TTL levels. your problem might be with the baud rate.

  • I had problems issuing commands to the unit using tera term. I figured out the problem was that the carrage return and line feed were not being transmitted. To fix this go to setup-> terminal and change Transmit: pull-down to CR+LF. I also turned on the local echo to see what was being sent. I also found it easier to copy the entire command you want to send onto your clipboard through notepad or something. Then right-click in the tera term window to paste it all at once in between the output strings and hit enter real quick. Also make sure the checksum value is correct. A quick calculator is found at http://nmeachecksum.eqth.net/ Hope this helps. Also helpful to determine the orientation of the chip is the GPSFox software downloadable from the locosys support website. Oh, yeah and to change the accelerometer output rate to 5Hz use $PLSC,248,1,2*1D.

No public wish lists :(