Member #258219

Member Since: October 11, 2011

Country: United States

  • Product PRT-08815 | about 2 years ago

    Would anyone mind explaining the basic/typical usage for these double-sided protoboards?

    It seems obvious to me (a newbie) that the square pads make up the ‘under side’ of the board, and that my components would be laid out on the side with the ground plane, correct? How is the ground plane used then? Do I solder bridge a ‘top side’ connection from the ground plane to one of holes so that the corresponding pad underneath becomes ground?

  • Product GPS-11058 | about 2 years ago

    Can anyone recommend ways to mount this unit? What are some common methods for these small boards with no mounting holes?

No public wish lists :(