Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
Member Since: October 16, 2011
Country: United States
News - November Caption Contest about 8 years ago
Beardy bear is OK.But a banana?
Product ROB-11056 about 8 years ago
I hooked this beast up with 2x12 Sabertooth and 6000mAh 2S Lipo.It was quite fun but sadly after one day(!) two motors went dead.Is there some problem with 2S Lipo or did I had just some bad luck?
Product COM-11169 about 9 years ago
Yes it helped me very much indeed.
News - A Good Ol' Fashioned Capt… about 9 years ago
They said voodoo....But to get this work I had to pretend I am viking!
Product ROB-11056 about 9 years ago
from other shop with this item: Stall current at 7.2 V: 6.6 A per motor No-load current at 7.2 V: 420 mA per motor
so I am not sure if the Wild Thumper Controller Board with 15A per channel is good enough to drive 3x6.6A at stall...
Product DEV-09815 about 9 years ago
Hi, I have two of theese in my vehicle project.I have made them work in a minute but after some time(2 days) they stopped responding to any direction change.What can be the problem?I am using them with arduino uno and 4 12V/2A motors.I even added some heatsinks on the bridges.
No public wish lists :(