×

SparkFun Electronics will be closed on July 3rd, 2015 in observance of Independence Day. Any orders placed after 2:00pm MT on July 2nd will be shipped out after the weekend. Thanks!

WickedMindsElectronics

Member Since: October 18, 2011

Country: United States

  • Who wants a socket for this camera? We just got some in stock for a product we are working on that uses this camera and had to order more than we needed. It’s far easier to solder and is oven/frying pan safe.

  • I have this cam writing frames directly into an SRAM chip I pulled off an old hard drive. Which I then read with an ATMega.

    Wrote up some info in the forums about it:

    http://forum.sparkfun.com/viewtopic.php?f=5&t=10314&p=128344&hilit=TCM82#p136406

  • Has anyone tried this with scissor cut board? We recently purchased a stack of the stuff and it’s so thin I am curious if this is beneficial to the process or not…
    Also, not using any paste, when I put solder on the pads with my iron, it leaves a rounded surface on the pads which makes the component hard to keep in position. Is there something sticky to pin it in place that is heat safe?

No public wish lists :(