×

SparkFun Electronics will be closed on July 3rd, 2015 in observance of Independence Day. Any orders placed after 2:00pm MT on July 2nd will be shipped out after the weekend. Thanks!

polto

Member Since: November 6, 2011

Country: United States

  • Hi, I got this sensor before and it was perfectly working. Got two more recently and they seems to be programmed differently.

    I connected the ePIR module to an RS232 and checked the pin5 config, it’s in Reset and not MD mode by default. I can change the config to MD while I am connected to the RS232, but as soon as I reboot the ePIR module the config goes back to Reset on pin5.

    How can I save the config ? Can not find anything specific about that in the manual.

    Thanks for any advice.

No public wish lists :(