×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

brian_eagan

Member Since: December 25, 2011

Country: United States

  • I just wanted to report success with this on an Arduino Mega, as there have been a few people who have had difficulty.

    Only needed TX, RX, 3.3v & GND

    When using the Arduino IDE console to send AT commands, note that you have to send a CR for your AT commands to register as complete to the device : )

No public wish lists :(