×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

charlie999

Member Since: December 26, 2011

Country: United States

  • addendum: the serial shield also uses SPI but the library that controls it (SD card) allows the CS pin to be set separately. if anyone is wondering that serial/sd shield is the itead gps

  • Will there be any compatibility issues using this shield with a UNO R3 and a SF AM/FM shield (DEV 10342) also running on the SPI bus? I also intend to use a shield that will occupy the serial outputs (D0 and D1 (UART protocol if it matters)) and several TWI sensors which I assume will not interfere apart from potential power issues.

No public wish lists :(