×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #282807

Member Since: January 9, 2012

Country: United States

  • One warning if you solder the 90 degree header pins to the pads as depicted in the Connection Tutorial: I went this route, then installed the unit on a breadboard. Worked flawlessly while designing circuit. Once things were working I removed it from the breadboard so I could mount it permanently. Unfortunately just the pull on the pin from this removal was enough to lift one of the ground pads; it took me a while to spot what was going on. I was able to apply a greenwire 'fix' by soldering a jumper from the remaining pad to a bit of trace I exposed with an xacto, but still kind of a shame; now I have to order another one because I don't trust my connection will stand up to abuse. Next time I'll mount it on standoffs and just solder a cable in place.

No public wish lists :(