×

Hello and Welcome! If you have a technical question please check out our Forums. If you have an order or shipping question please refer to our Customer Support page. Please see all COVID-19 updates here and thank you for your continued support.

ikaros66

Member Since: January 11, 2012

Country: United States

  • Is there any documentation of the actual protocol used in the serial/I2C/SPI/USB protocol? I went through some of the examples and there seem to be various bytes that you sent before sending special commands, others to enable commands etc., but it is really awkward to have to reverse engineering the protocol by tracing through arduino-ish libraries. It would be great to have some clean documentation on the protocol that is product agnostic.

    Along the same lines, it couldn't hurt to provide a specification table with the function of each pin so one wanting to integrate this into their project doesn't have to trace through the tutorial magnifying each photo trying to figure out what goes where.

  • If I set the voltage jumper to VSYS, would there be any problem with powering the whole stack by providing 4.5V at JP2?

  • I can confirm that the block can properly power a stack but the UART does not work as explained in the review (high frequency oscillations messes up the signal). Has there been any update on this?

No public wish lists :(