×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

brcox0789

Member Since: January 16, 2012

Country: United States

  • Apparently the D3 pin needs to be used for the SPI CS line.

  • Yes, that is correct, I am using the same scheme although I haven't tested it on the new board yet. I'm assuming WP stands for write protection, but not sure what to connect to that pin if I am not using it. The datasheet says to put pull-up resistors on any unused connections namely D1 and D2.

No public wish lists :(