×

SparkFun Electronics will be closed on November 26, 2020 and November 27, 2020 for the Thanksgiving holiday. We will begin normal operations at 9:00 AM Mountain Time on November 30, 2020.

×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #294013

Member Since: January 17, 2012

Country: United States

  • You list the power pin (3v3) as "output only". The schematic and my testing show that you can power the microbit through the 3v3 pin of the edge connector. As noted in the microbit documentation, you must insure that power does not exceed 3.6v.

  • I couldn't get this to work with UNO (5v) using the 10k resistors (998 errors). I had to use a level converter.

  • FYI -- got this display working with Maple arm (arduino-like) board in serial mode using UART Tx (Serial1) and with SPI at the slowest SPI frequency (140 kHz) and also works at 281KHz

No public wish lists :(