Member Since: February 16, 2012

Country: United States



Home is Where the Hand Is.

  • Product DEV-10524 | about 2 years ago

    So, Refund or Reship? Is that what we should tell tech support?

  • Product COM-10390 | about 2 years ago

    Any advice on how to wire these parallel? Common Cathode parallel would require a resistor between each connection correct? I.E. Red_Red_Red_, each ‘jump’ would need a resistor?

  • Product DEV-10524 | about 2 years ago

    I Bought three of these boards and they all seemed to load sketches perfectly from my uno. However after i remove power (usb) from the board, they chip seems to reset itself. When i re-apply power (usb) the sketch is no longer on the chip and the it seems to have fallen into a default setting. Im no expert at this just wondering if anyone else is having this problem? Also, it is only with these chips. The 328 that comes with the UNO seems to be working fine after disconnecting an reconnecting power.

No public wish lists :(