×

SparkFun Electronics will be closed in observance of memorial day on Monday, May 29th. We will resume normal business hours on Tuesday, May 30th. Any orders placed after 2pm Mountain Time on Friday, May 26th will process and ship out on Tuesday, May 30th.

orbian

Member Since: February 29, 2012

Country: United States

  • Any esitmates on when these will be back in stock?

  • Has anyone gotten these to work with an Arduino? I’ve been able to hook up the breakout board to the Arduino via a 74LVC245. I can read and write registers with SCI and initiate a sine test with SDI but when I send MP3 data via SDI it pretty much just locks up. Sometimes I’ll get something that sounds like its trying to decode but its usually garbled or just silence. It takes a power recycle to get the chip to respond again. Here’s what I’ve done in software:

    Set the clock to 0x9800 like the data sheet says for a 12.288 Xtal SPI is MSBFIRST, SPI_CLOCK_DIV8, SPI_MODE0 Set mode to SDINEW Drop CS low for SCI enable and drop XDCS (BSYNC) low for SDI enable.

    My guess is it has something to do with byte syncing for SDI. But the 8 byte SDI tests sequences work. I check DREQ to make sure its high before sending but I rarely see it go low.

    If anyone has had any luck I’d love to hear what you did.

No public wish lists :(