Benjamin_krogh

Member Since: March 27, 2012

Country: United States

  • Product GPS-11058 | about 2 years ago

    Just skip my comments. Apparently there is some subtle bug in the arduino mega. The following two are NOT equivalent (only the former works for some reason).

    define baud 38400

    Serial.begin(baud)

    const int baud 38400 Serial.begin(baud)

  • Product GPS-11058 | about 2 years ago

    Okay I found out that ROM sets baud rate to 4800, instead of the default 9600. However, when setting the baud rate to anything >= 38400 my arduino mega does not report anything. 4800, 9600 and 19200 works fine for some reason. This, however, removes the option of flashing the device as the SkyTraq software automagically and unpreventable sets the baud rate to 115200. Any clues on how to fix this?

  • Product GPS-11058 | about 2 years ago

    I lost control of my chip but cannot get it to reset. I should just unsolder the left and middle pads in BTS and solder the middle and right pads instead?

    I get output, at a seemingly correct rate, but the characters are completely mangled.

No public wish lists :(