×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

Member #313880

Member Since: April 1, 2012

Country: United States

  • Just to help everyone out, this board works perfectly fine once a short jumper wire is soldered between the IRQ pin connected to the header JP4.5, and the /IRQ net on the chip side of the pull-up resistor R2. Just make sure that R2 is not disconnected from its pad when soldering on the jumper wire.

No public wish lists :(