raican

Member Since: April 4, 2012

Country: United States

  • Product BOB-09118 | about 2 years ago

    I’m trying to use this with a Fez Panda 2 to activate an RC Car ESC. The feed from the ESC is 7.6v which is connected to HV. HV_GND is connected to the ground wire from the servo plug. The ‘on’ wire, which is normally shorted to the power feed by the on switch (now disconnected) is connected to OUT1.

    I have tried IN1 connected to one on the digital outputs, the regulated 5v pin, and the Vin pin (separately) but OUT1 is only about 1.6v when IN1 is high. (It’s 0v when IN1 is low).

    Any ideas what I’m missing?

    Thanks in advance.

No public wish lists :(