JacobIngalls

Member Since: April 8, 2012

Country: United States

  • How do i hook this up to an Arduino? I understand that i can communicate serially, but the board is not labeled. Are the four pads at the bottom where wires go? From the last picture the wires are blue, black, red, white. Tx, Gnd, +5, Rx? Thanks for any help, I’m sure i’m missing something obvious.

    is it the same as http://www.openservo.com/OpenServoPinout#Pinout_configuration_for_the_1.x_and_2.x_OpenServo_connector. SCL, Gnd, +5, SDA Using I2C?

SLAM

JacobIngalls 16 items

http://www.adafruit.com/products/814 http://www.servocity.com/h…