×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

camow7

Member Since: May 19, 2012

Country: United States

  • This is a schematic of the circuit that is functioning perfectly: http://www.dfrobot.com/image/data/DFR0050/XBEE%20Adapter%20SCH%20DFR0050.pdf

  • I have two Xbee S3B 900HP's configured to talk to each other correctly. I have tested the link in both XCTU and using my eBay Xbee explorer and confirmed it's functional. I had also read that the RSSI can cause issues so I removed the resistor to the LED.

    Is it possible that 1K pull-up on the level shifting FET is a bit strong?

  • I bought one of these to wire into a Pixhawk as described here: http://copter.ardupilot.com/wiki/common-optional-hardware/common-telemetry-landingpage/common-telemetry-xbee/

    And I can not get it to work no matter which way I wire the TX and RX lines (I'm using an Xbee S3B 900HP). My Xbee works perfectly with: http://www.ebay.com.au/itm/XBee-Explorer-Xbee-USB-Mini-Adapter-With-Free-USB-Cable-Module-Board-Base-/181479114444?pt=LH_DefaultDomain_15&hash=item2a40ff86cc

  • The Arduino Buying Guide says that this board can be powered from 3.3v to 12v. What pin do I wire to my 12v battery in order to power it?

No public wish lists :(