×

Our Technical Support team will be out of the office on Wednesday, April 23 starting at 12pm. Tech Support will reopen with normal hours on Thursday, April 24 at 9am. Thank you

Member #326348

Member Since: May 22, 2012

Country: United States

  • Product PRT-00449 | about 2 years ago

    OK… I just recieved this item and in testing a loopback I cannot get anything to show in the terminal. The tx led stays lit constantly and if I wiggle or connect and disconnect the the loopback wire the rx led will flicker (as I assume it should)and I get randem characters in the terminal. Any help?

    Specs: I’m powering it on the same power supply that the meachine is running in connected to the +5v and ground on the molex connector. I’ve ensured the baud rate etc… have been set. What am I missing? Help???

No public wish lists :(