SparkFun will be closed Monday 7/4 for the holiday. All orders placed after 2pm MT on Friday 7/1 will be shipped out next week.

Member #327565

Member Since: May 28, 2012

Country: United States

  • Is there any clearer diagram or even better fritzing.org drawing available on how to connect the MagnetoPot correct to V+ (red), GND (black) and collector (yellow) (e.g. A0 on Arduino Board)? E.g. there is a triangle and a B available direct on the sensor which might be used as reference points on where to connect? See e.g.: http://ropeandpulley.com/blog/wp-content/uploads/2011/12/theMaids-Drawer-Sensors-2011-12-09_bb.pdf Note: Not sure if this is correct?

No public wish lists :(