Member #330095

Member Since: June 7, 2012

Country: Australia

  • I was just looking at the schematic of this break out board. What is the purpose of R1 (100ohm resistor in serial with VDD)? I understand this configuration is recommended on the Page 1 of the ISL29125 datasheet, but on ISL29125 Evaluation board, this resistor is omitted (Page 7 of AN1914, found on: http://www.intersil.com/content/dam/Intersil/documents/an19/an1914.pdf). Could someone give me some help? Cheers,

No public wish lists :(