×

Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.

johnp

Member Since: April 11, 2006

Country: United States

  • I've got a prototyping board up on BatchPCB that fits this case: http://batchpcb.com/index.php/Products/43964

  • I make slots in my boards by stacking drill hits. I've had good luck with BatchPCB using this technique.

  • Reading the datasheet, the gain spec for a GPS antenna should be "1.5 dBi < Gain < 4.5 dBi". All of the antennas I've seen here appear to have a much higher gain than this. Am I missing something?

  • Can the UART be accessed with this model? It looks like there isn't an external connector as with the -BOX variant. Perhaps the connections are available on the board underall that heat-shrink?

  • If you really can't wait to have one of these, order directly through Saleae. They are shipping them pretty much immediately.

No public wish lists :(