Member #337391

Member Since: July 11, 2012

Country: United States

  • Product COM-10963 | about 2 years ago

    Hi! I am using an atmega168 DIP packaged microcontroller with the EasyVR (instead of an arduino board). So far, I have successfully connected the EasyVR to my PC and ‘trained’ the chip using EasyVR commander. Now, I am trying light up an LED when a specific word is detected. I am using AVR Studio 5.1 to program the atmega168, in C programming language. My question is: are there any code templates or source code examples to help get a better picture of how to communicate between the host and easyvr? I have already added all the necessary files for UART serial communication, and the protocol.h file. Now I am just trying to figure out the syntax/general code structure on how to send/receive a specific command (like ‘q’ or ‘o’) through rx and tx.

No public wish lists :(