Member #344341

Member Since: August 9, 2012

Country: United States

  • Product SEN-10619 | about 2 years ago

    Has anyone ever had luck programming these devices in LabVIEW in conjunction with a National Instruments USB-8451? Can you please post?

  • Product SEN-10619 | about 2 years ago

    Hi,

    I’m just got this device, and I’m trying to hook it up to a NI-8451 (http://sine.ni.com/nips/cds/view/p/lang/en/nid/202368) or a Diolan DLN series (http://www.diolan.com/comparison/dln.html) I2C to USB converter.

    Some questions since I’m new to this.

    1.) Which pins on this breakout board do I solder to? Obviously VCC and GND, but SDA is your signal, and SCL is your clock? Just double checking. Any special type of wire gauge?

    2.) How about if we wanted to hook up more than one magnetometer to the I2C to USB converter? Anyone have any knowledge with bus expanders?

    Thanks!

No public wish lists :(