×
Prolonged severe weather across the U.S. is causing delays including the ability to transport and deliver packages in certain cities. Please see here for more details. Thank you for your continued support and patience.
×
Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.
repurposer
Member Since: March 14, 2008
Country: United States
-
The schematic for v11 shows pins 1, 2, and 4 (all GND) are connected to a "SI_STRIP", and not ground. The datasheet from Simblee doesn't give me any clue about why this was done?
-
tie pin
-
No, sir I have not seen your friends Clippy and Rover. Please do not disconnect power while I install a new driver for your FTDI FT232 robe
-
looks like you could solder the surface mount usb mini b connector instead. I prefer compatibility to compactness, in this case!
No public wish lists :(