Please see all COVID-19 updates here as some shipments may be delayed due to CDC safety and staffing guidelines. If you have an order or shipping question please refer to our Customer Support page. For technical questions please check out our Forums. Thank you for your continued support.


Member Since: August 24, 2012

Country: United States

  • This may seem like a stupid quesition but how do you use the buttons? They are wired to connect the arduino pins to ground when pressed. The standard way to use a button is to wire the pin to ground via a resistor and run +5V to the pin from the button, pulling the pin to HIGH when the button is pressed. For this board do I need to run +5V to the each pin to pull them HIGH by default and let the button pull them to LOW? Am I missing something?

No public wish lists :(