Member #356503

Member Since: August 29, 2012

Country: United States

  • Product DEV-09947 | about 8 months ago

    I was not able to get Oleg V2 library to work on the shield until I put the jumper from D7 to RST. Initially, hesitated to put the jumper, but after I read all the comments and I looked at the schematics. I realize that Oleg V2 Library should be resetting the RST line if it is not using Pin D7 to do the job. But make sure you do not connect the D7 on the shield to the Arduino. You only connect D8-D13 to the Arduino, otherwise you will be shorting the Arduino D7 to RST. If you set Pin7 as output and high, this should also prevent Pin D7 from resetting Arduino (if D7 is still connected between Shield and Arduino).

No public wish lists :(